All plastic components are Made in Germany and have been CNC milled, which allows a good fit of all parts, such as switches, LED sockets, window, feed hatches and the use of the sweeper 28mm Jets.
The set contains all components necessary for a complete fuselage:
Scope of delivery
RT3 fuselage lower part
RT3 Fuselage upper part
RT3 Battery cover
RT3 Battery box
illuminated stainless steel switch
Window for voltmeter milled
Feed hatches 4mm Plexiglas milled
Castings Ball bearing holder for feed hatch
Ball bearings for feed hatches
stainless steel shafts 4mm, 33,5cm
Knurled screws with socket
Metal Sockets for 5mm Leds
Sockets for 10mm Leds metal optics
We also offer the Kehrer Jet as a complete set with servos, mounts etc.. Of course, the RT3 can also be assembled with a screw/rudder drive or with 2 motors (left and right).
The boat is designed for a total load capacity of 4 litres (2 litres per side). With the enormous dimensions of the feed hatches of 32cm length and 9 cm width a tilting of Baits is completely impossible. Even tennisball-sized feedballs or baitfish assemblies can be extended without any problems. Instead of lipo batteries, cheap NíMh or lead batteries can also be stored in the battery compartment. Further information about the hull can be found under RT3 Baitboat -> Technical Details.
The two feed hatches can be opened by servo-controlled plastic pins or by our magnet system. A 4mm stainless steel shaft is fastened under the feed hatches, which are fastened at the ends in ball bearings at the boat. Thus the hatch moves reliably and quietly, in contrast to otherwise usual hinges.
We give 2 years warranty on the fuselage set, self-inflicted defects are excluded from this. A reorder of individual components is possible at any time.
229€ instead of 299€! Only for a short time! CURRENTLY NOT AVAILABLE!